Back to Lift and Escalator Mechanic Info & Full CBT6 Exam Qs (12 Marks) • 16 Practice MCQsDGT Syllabus PDF Report Wrong Info

Lift and Escalator Mechanic — Engineering Drawing NCVT Mock Test

Q: What topics should I focus on for Lift and Escalator Mechanic Engineering Drawing?

Key Engineering Drawing chapters: Drawing sheets (A0–A4), title block & pencil grades (HB, 2H, 4H); BIS lines (continuous thick, dashed hidden, centre chain lines); First-angle vs Third-angle orthographic projection symbols; Isometric projection, screw threads, rivets & circuit symbols.

Q: How do I practise the other CBT subjects for Lift and Escalator Mechanic?

Use the subject switcher tabs directly above the test simulator to jump between Trade Theory, Workshop Calculation & Science, Engineering Drawing, Employability Skills, or open the Full CBT Mock Test on the Lift and Escalator Mechanic trade page.

Engineering Drawing (ED) is now evaluated through visual MCQs in the NCVT CBT exam (6 questions, 12 marks) covering BIS standards, projection angles, isometric views, and electrical/mechanical symbols. Practise verified objective questions tailored for Lift and Escalator Mechanic trainees (2 Years • Power • Engineering).

Switch Lift and Escalator Mechanic Subject:Trade Theory Workshop Calculation & Science Engineering Drawing Employability Skills Combined Full CBT

NIMI / DGT CBT Simulator

Lift and Escalator Mechanic — Engineering Drawing Mock Test

Integrated into CBT Theory Paper (33% overall CBT pass threshold) • Zero Negative Marking

Questions

Max Marks

Time Limit

24m

Neg. Marking

NONE

Choose Test Mode

Shows the right answer and NIMI technical explanation immediately after each question.

Trade Info:Engineering (2 Years • Level 4)•Open Lift and Escalator Mechanic Full Page

Important Engineering Drawing Topics Covered

All Trades for Engg. Drawing →

Drawing sheets (A0–A4), title block & pencil grades (HB, 2H, 4H)

BIS lines (continuous thick, dashed hidden, centre chain lines)

First-angle vs Third-angle orthographic projection symbols

Isometric projection, screw threads, rivets & circuit symbols

Lift and Escalator Mechanic trainee wearing yellow hard hat and full safety harness crouching on a lift car roof top inspection station adjusting the geared traction sheave, hoist steel ropes, and green AC drive motor

Chemical Plant, HVAC & Pumps Lab

Lift & Escalator Traction Sheave and Hoist Motor Bay

Inspecting multi-groove traction sheaves, governor steel wire ropes, gearboxes, and top-of-car emergency-stop inspection controls.

Content Verification & Error Reporting

Notice an incorrect MCQ, option, or explanation in Lift and Escalator Mechanic Engineering Drawing? Send the Question ID directly on WhatsApp (+917585821444).

Report Incorrect Info on WhatsApp

Frequently Asked Questions

In the official DGT Computer-Based Test for Lift and Escalator Mechanic, Engineering Drawing accounts for 6 Multiple Choice Questions carrying 12 marks (2 marks per correct answer, no negative marking).

Navigate directly between NCVT CBT practice papers and official portal guides.

View Complete Sitemap

Mock TestsInteractive CBT